MicroNet SP5001D Manual de usuario

User’s Manual IP Telephony Gateway Model No.: SP5001C, SP5001D, SP5002A, SP5012A World Wide Web: www.micronet.com.tw ; www.micronet.info

9SP5012A: SP5012A Front Panel LED Status Description PWR On/Green Power On TEL On/Amber Line Registered LINE On/Amber Line Registered LAN On/Gr

101.3 Application SP5001C: ● 1 RJ-11 FXS port is provided for phone set or PBX's trunk line connection ● 2 RJ-45 ports of 10/100M are prov

11SP5001D: ● 1 RJ-11 FXS port is provided for phone set or PBX's trunk line connection ● 1 RJ-11 PSTN port is provided to tranceive PSTN cal

12VPN (Virtual Private Network) The IP telephony gateway series supports PPTP client for VPN function. It can establish VPN tunnel with PPTP server,

132. Startup 2.1 Login into the System The embedded web configuration allows you to use a web browser to manage the IP Telephony gateway. Step

14

152.2 Network Configuration By default, the gateway is in NAT mode (router mode) and can share Internet access with PCs. Go to [ Network / WAN Set

16 ----------------------------------------------------------------------------------------------------- Parameter Description -------------------

172.3 SIP Configuration Go to [ SIP Settings / Service Domain ]. Each port can be configured to register 3 different service domains. ---------

18 ----------------------------------------------------------------------------------------------------- Note: Please save and reboot the system to

1About this User’s Manual This User’s Manual gives users basic steps on installation and operation. Please read this manual chapter by chapter. C

192.4 VPN Configuration IP telephony gateway supports PPTP client for VPN. It can establish VPN tunnel with PPTP server. Go to [ Network / PPTP Set

20After tunnel is established, the gateway gets one private IP address (Interface 2) from PPTP server as shown in [ Network / Status ].

21 2.5 DDNS DDNS allows you to map the static domain name to a dynamic IP address. You must get an account, password and your static domain name fr

223. Operation 3.1 Make a Call By default, call is sent via the first registrar server only. The telephone number of clients in the second/third s

23 3.2 Speed Dial / P2P call Speed dial Press <index> + # Go to [ Phone Book / Speed Dial Setting ]. User can create 10 entries (0~9) in

243.3 Call Forward Go to [ Phone Setting / Call Forward ]. There are 3 selections in Forward type. User must select the condition under which to fo

253.4 Call Hold / Call Waiting / Conference The IP telephony gateway provides telephony features, as call hold, call waiting, and 3-way conference.

26 3.5 FAX Send FAX ● Press <fax_number> to connect fax machine ● Start to send FAX T.38 FAX: Go to [ Phone Setting / T.38 (FAX) Setting

27 4. Web Administration 4.1 Phone Book Please refer to the section 3.2 Speed Dial / P2P call. 4.2 Phone Setting 4.2.1 Call Forward Please

28 4.2.4 Block Settings User can set up the gateway to block incoming calls and the period. 4.2.5 Caller ID User can set the device to sho

2Table of Content 1. ..Introduction... 4 1.1 Key Features

29 ----------------------------------------------------------------------------------------------------- Parameter Description -------------------

30* means: keypad＊ on the phone x means: digit 0, 1, 2~9 # means: keypad # on the phone + means: or Auto prefix: 02 (0000~9999) Input Sent out 221

31 4.2.9 T.38 (FAX) Setting Please refer to the section 3.5 FAX.

32 4.3 Network 4.3.1 Status User can check the current Network setting. 4.3.2 WAN Settings Please refer to the section 2.2 Network Configura

33----------------------------------------------------------------------------------------------------- Parameter Description ---------------------

344.3.6 PPTP Settings Please refer to the section 2.4 VPN Configuration. 4.3.7 DMZ * Open another page http://192.168.123.1:9999/dmzset.htm. Wi

354.4 SIP Settings 4.4.1 Service Domain Please refer to the section 2.3 SIP Configuration. 4.4.2 Port Settings User can set up SIP and RTP po

36 4.4.4 Codec ID Settings User can set up codec ID for different codec. This ID represents the codec used to encode data in the Track. 4.4.5

37Symmetric Response Routing. This behavior is not desirable in many cases. Please configure it according to your service provider. 4.4.7 Other

38EF (Expedited Forwarding). ----------------------------------------------------------------------------------------------------- SIP expire time

34.3.7 DMZ * ... 34 4.3.8 Virtual Server *

394.6 Others 4.6.1 Auto Config User can disable Auto Configuration or enable the function by TFTP/FTP. Please contact with your service provider

404.7 System Auth. Change system login name and password. 4.8 Save Change Click on the Save button. The system will automatically restart and

41 Click on the Update button to start upgrading. 4.9.2 Default Setting Click on the Restore button. Then, the system will restore factory defa

425. IVR / Keypad Management You can use the PSTN phone keypad to operate the IP Telephony gateway. Please follow the instruction to configure. IV

43Use the * (star) key when entering a decimal point. Set Network Mask #113xxx*xxx*xxx*xxx# Enter value-using numbers on the telephone keypad. Use

446. Specification Model SP5001C SP5001D SP5002A SP5012A Standard IETF SIP (RFC3261) Telephone Port 1 FXS 1 FXS 1 PSTN (lifeline) 2 FXS 1 F

41. Introduction Micronet SP5001C, SP5001D, SP5002A and SP5012A IP Telephony Gateway is designed to connect standard telephone devices to IP-based

5 1.1 Key Features z Compliant with IETF SIP standards z Provide 2 10/100M RJ-45 ports for WAN and LAN connection z Support G.729a/b, G.711a/µ-l

6 1.2 Physical Description SP5001C: SP5001C Front Panel LED Status Description PWR On/Green Power On STATUS On/Amber Line Registered TEL On/

7SP5001D: SP5001D Front Panel LED Status Description PWR On/Green Power On PSTN On/Amber PSTN mode / VoIP Unregistered TEL On/Amber Phone se

8SP5002A: SP5002A Front Panel LED Status Description PWR On/Green Power On TEL1 On/Amber Line Registered TEL2 On/Amber Line Registered LAN On/