MicroNet SP5012A Manual de usuario descargar pdf (Pagina 49)

5.2 [quit]

Type quit will quit the Gateway configuration mode and turn back to login

prompt (in console mode) or disconnect (in TELNET mode).

usr/config$ quit

Disconnecting...

Note: It is recommended that type the “quit” command before you leave

the console. If so, Gateway will ask password again when next user

connects to console port.

5.3 [debug]

Open debug message will show up specific information while Gateway is

in operation. After executing the debug command, it should execute

command debug -open as well. One example is demonstrated below.

usr/config$ debug -add fsm vp

usr/config$ debug -open

In this example, user open debug flags including fsm, vp.

Parameters Usage:

-status Display the enabled debug flags.

-add Add debug flag.

-- fsm: sip related information

-- vp : voice related information

-delete Remove specified debug flag.

-open Start to show debug messages.

-close Stop showing debug messages.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 83 84

Sin comentarios

MicroNet SP5012A Manual de usuario Pagina 49