MicroNet SP5001C Manual de usuario descargar pdf (Pagina 65)

19.7 System Commands Overview

19.7.1 [quit]

Type quit will quit configuration mode. And turn back to login prompt.

usr/config$ quit

Disconnecting...

Welcome to Terminal Configuration Mode

Please enter your configuration item

Figure 37. quit command list

Note: It is recommanded that type the “quit” command before you leave the

console. If so, SP5001/S will ask password again when next user connects to

console port.

19.7.2 [debug]

Open debug message will show up specific information while Gateway is in

operation. After executing the debug command, it should execute command

debug -open as well. One example is demonstrated below.

usr/config$ debug

Debug message information and configuration

Usage:

debug [-add type1 [[type2]...]] | -open | -close | -status

-status Display the enabled debug flags.

-add Add debug flag.

-delete Remove specified debug flag.

-open Start to show debug messages.

-close Stop showing debug messages.

Example:

debug -add sip msg

debug -open

usr/config$

Figure 38. debug command list

In this example, user open debug flags including sip, msg.

usr/config$ debug -add sip msg

usr/config$ debug –open

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Sin comentarios

MicroNet SP5001C Manual de usuario Pagina 65