MicroNet SP1910 Manual de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 88
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
30
On this page, you can configure VPI and VCI values (consult your local ISP if you are not
clear). For other options, keep the defaults and click the “ Apply/Save” button.
2. In Ethernet modes, you are required to configure parameters for Ethernet interface.
To enter the ETH Interface page, click “ Advanced Setup” ---“ Connection Mode”
(Select Ethernet mode and click “ Apply” ) --- “ WAN Service” ---“ ETH Interface” .
And then click the “ Add” button to configure relevant parameters.
The Ethernet interface configured on this page is used as a WAN port. You can select only
one LAN interface to function as a WAN port. Once you finish, click the “ Apply/Save”
button.
4.3.3 WAN service
WAN Configuration in DSL Mode
-PPP over Ethernet (PPPoE)
Click “ Advanced Setup” —“ Connection mode” (Select DSL mode and click
Apply” )---“ WAN Service” ---“ ATM Interface” (refer to 4.3 for configuring the ATM
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Comentarios a estos manuales

Sin comentarios