MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario descargar pdf (Pagina 154)

FIBRE-to-SAS/SATA RAID SUBSYSTEM

154

User Manual

For PRO-90-6601 SES board:

NOTE: The upgrade process is done twice. The first time needs a

jumper in JP8. The second time does not need a jumper.

a. Power off the RAID system. Remove the SES Module. Insert a jumper in JP8

of SES board PRO-90-6601.

b. Insert the SES module into the RAID subsystem. Power on RAID subsystem.

c. Connect RS232 cable (Phone-Jack to DB9) from RS232 port of SES module to

available serial port of your PC.

d. Open “HyperTerminal” in your Windows PC and setup as follows:

Settings

Baud Rate 38400 (for SES board PRO-90-6601)

Data Bits 8

Parity None

Stop Bits 1

Flow Control None

e. To access the SES console, press <ENTER> at least once to verify the SES

console session has been established (a “-->” prompt should appear if

configured properly).

f. At the prompt, type “proses upgrade”, followed by <ENTER>.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 160

Sin comentarios

MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario Pagina 154