MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario descargar pdf (Pagina 76)

FIBRE-to-SAS/SATA RAID SUBSYSTEM

User Manual

2. Select the RAID level to be created. Currently RAID levels 0, 1, 5, 6 and 10 are

available.

NOTE: To create a RAID 10, select multiples of two disks and select

RAID 1. The RAID Level will still show as “RAID 1” but the RAID

capacity is correct.

3. Enable ‘Write Cache’ if you want the controller to respond with Good status when

the data is written to the cache, but before it is written to disk.

4. Enable ‘Read Cache’ if you want the controller to store the data most recently

retrieved in the cache.

5. Enable ‘Read Ahead’ if you want the controller to optimize performance on

sequential reads.

6. Enable ‘Disk Caching’ if you want the controller to enable disk caching.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 159 160

Sin comentarios

MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario Pagina 76