MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario descargar pdf (Pagina 110)

Fibre to SAS/SATA II RAID Subsystem

110

User Manual

6.3 Replacing Subsystem Components

6.3.1 Replacing Controller Module

When replacing a failed Controller Module, please follow these steps:

1. Loosen the thumbscrews on the sides of the Controller Module case.

2. Use the Controller handle to pull out the defective Controller.

3. Insert and slide the new Controller in. Note that it may be necessary to remove

the old/defective Controller Module from the case and install the new one.

IMPORTANT: When the subsystem is online and a Controller module

fails and the replacement is not yet available, in order to maintain

proper airflow within the enclosure, the failed module can be

removed from the enclosure and the Plate Cover for Controller can

be used in place of the failed module. (Refer to next section).

When replacing a failed component online, it is not recommended

to remove the failed component for a long period of time; proper air

flow within the enclosure might fail causing high controller/disk

drive temperature.

4. Tighten the thumbscrews on the sides of the Controller Module case.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 137 138

Sin comentarios

MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario Pagina 110