MicroNet Fibre to SAS/SATA II RAID Subsystem Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 138
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
Fibre to SAS/SATA II RAID Subsystem
36
User Manual
Chapter 4 RAID Configuration Utility Options
Configuration Methods
There are f o u r methods of configuring the RAID controller:
a.
VT100 terminal connected through the serial Monitor port
b.
Front panel touch-control buttons
c.
Web browser-based remote RAID management via the R-Link Ethernet port
d.
Telnet connection via the R-Link Ethernet port
NOTE: The RAID subsystem allows you to access using only one
method
at a time. You cannot use more than one method at the
same time.
4.1 Configuration through Terminal
Configuring through a terminal will allow you to use the same configuration options
and functions that are available from the LCD panel and via Telnet. To start-up:
1. Connect the Monitor port located at the rear of the system to a PC or a VT100
compatible terminal operating in an equivalent terminal emulation mode using serial
cable.
NOTE: You may connect a terminal while the system’s power is on.
2. Power-on the terminal.
3. Run the VT100 program or an equivalent terminal program.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 137 138

Comentarios a estos manuales

Sin comentarios